Apply the electronic parking brake.
Parking brake cable adjuster enabling.
The adjustment bolt will be located on the parking brake lever.
Raise the park brake lever.
Adjusting the parking brake.
Raise and support the vehicle.
Adjust the parking brake.
The brake cable adjuster is usually located in one of two different places.
Our parking brake cable shortener is engineered to effectively take up excess slack in cables.
69 3 in rear drum brakes.
Attempt to rotate the rear tire and wheel assemblies.
It s constructed from high quality materials for long lasting service.
If your parking brake cable has been damaged o reilly auto parts carries replacement parking brake cables for most vehicles.
The wheels should not rotate forward.
Lift the park brake lever boot to gain access to the multiplier lever at the front of the park brake lever assembly.
The parking brake lever can be foot actuated and mounted to the driver s left or hand actuated and mounted at the driver s right in the center console.
Place the transmission in neutral.
One inside the vehicle and one outside the vehicle.
A parking brake cable can stretch rust or seize due to wear.
Raise and support the vehicle so the tire and wheel assemblies are clear of the ground.
This bolt tightens the cable leading to the rear brakes.
Enable the parking brake cable adjuster.
Disabling the park brake cable automatic adjuster before any components of the parking brake system are serviced the following procedure must be followed.
Two technicians are required to perform this procedure.
1 year warranty 22.
Check the brake by pulling the lever up and feel for tightness.
Rely on your parking brake again and switch out that brake cable.
If the parking brake feels weak then the parking brake cable may need to have its tension adjusted.
Restores tight firm feel when pulling up the emergency brake handle.
Except push to release parking brake pedal.
Get free next day delivery or pick one up in store today.
Tighten the bolt by a few turns and then check the parking brake cable.
Save money by using the cable shortener instead of replacing the entire cable.
Either under the car about midway between the front and the rear or attached to the parking brake lever.
Brakeware brake cable c11660.
Cycle the park.
To enable after component replacement to reengage the the automatic adjuster complete the sequence below.
Lower the park brake lever.