Scrape away as much loose paint as possible using the paint scraper first and then the wire brush.
Paint peeling off walls in sheets plaster.
The plaster and oil based paint in the area looked sound but after we added a layer of latex primer the next day it began flaking off in huge sheets.
That area was right under the bathroom where there had been a leak now repaired.
Apply masking tape around doors and windows and above baseboards to protect these.
The paint in the living room is also doing the same which i m guessing has been there for about 2 years previous owners job.
Let your wall dry thoroughly.
How do i repaint a wall that has peeling paint.
2 for tight paint not peeling but showing cracks.
Look for anything that is loose and remove scrape.
This may have been a factor but it didn t damage the paint.
Apply a penetrating binding primer to seal up and glue down the old paint.
And the walls are holding up but flaking off to the point where it s just not salvageable.
Scraping and sanding the walls then applying a thinned wash of white matt is the best route to neutralise the problem even though it is a pain.
Let the soapy solution set on your wall for 5 to 10 minutes before removing with clean water.
Prime the affected areas then patch any damage.
Underneath the paint there is a chalky.
Gear up with goggles and a face mask because tiny flakes of paint are sure to go flying.
Use a sponge to scrub the area of paint around your bare plaster.
Clean the surface with a mild solution of soapy water.
A putty knife or paint scraper works well at removing the paint if you carefully move it along the loose edges.
Make sure to remove all peeling or flaking areas until the wall and ceiling only.
Peeling from plaster could be a result of insufficient wet troweling of the white coat when the plaster was originally applied causing chalking of the surface.
New plaster might have a high ph requiring the application of a primer resistant to alkalinity.
Lay down the drop cloths to cover the floor under the wall.
The reason the paint is peeling off is because it hasn t gripped the plaster so adding layers on top of a peeling layer won t solve the issue.
Very hard plaster may be slick reducing the adhesion of any coating.
At some points where we have had to remove it it has peeled off to the bare plaster.
Protect the floor with a drop cloth and have a receptacle handy to catch the refuse.
It ll just be a thicker layer to peel off.