Osha Roof Safety Monitoring System

This instruction applies osha wide.

Osha roof safety monitoring system.

A steep roof has a slope greater than 4 in. If you work alone you are not required to abide by osha standards. The safety monitor shall not have other responsibilities which could take the monitor s attention from the monitoring function. The safety monitor is always a competent person 29 cfr 1926 500 b.

According to osha a monitoring system can be used in combination with the solutions provided above. Most workers can be protected with conventional fall protection systems such as guardrails safety nets and personal fall arrest systems. Aerial lifts may be used to transport personnel so long as the requirements in 29 cfr 1926 453 which cover aerial lifts are met. Osha occupational safety and health administration is a us government agency regulating workplace safety.

A safety monitoring system is an alternative fall protection option for low slope roofing work. That person needs to be on the same walking working surface and warns the worker s when fall hazards are observed. If you are a roofing contractor in the united states with at least one employee you are required to abide by osha safety standards. As far as osha is concerned there is no safe distance from the edge of a roof so you must be protected.

This means that you must have rails fall arrest systems or a warning line safety monitor setup no matter where it is you are working. When engaged in roofing work on low slope roofs 50 ft or less in width the use of a safety monitoring system without a warning line system is permitted. 1926 502 h 2 mechanical equipment shall not be used or stored in areas where safety monitoring systems are being used to monitor employees engaged in roofing operations on low slope roofs. Division 3 subdivision m.

However 1926 501 b 10 further provides that. This instruction clarifies the use of a safety monitoring system to comply with 29 cfr 1926 500 g 1. Safety monitoring system as it applies to 29 cfr 1926 500 g 1 a. This requires the designation of a competent person to monitor the safety of workers and to warn them when their work puts them close to a fall hazard.

Safety monitoring for roofing work. Safety monitoring for roofing work. Oregon osha s division 3 construction rules set the requirements for the types of fall protection systems that can be used to. Vertical per 12 in.

Section 1926 453 b 2 v requires that employees working from aerial lifts be tied off. The warning line system shall consist of ropes wires or chains and supporting stanchions 29 cfr 1926 502 f 2. Or on roofs 50 feet 15 25 m or less in width the use of a safety monitoring system alone is permitted 29 cfr 1926 501 b 10. Osha instruction std 3 11 1.

This means a competent person monitors the worker s on a low slope roof. 29 cfr 1926 501 b 10 allows the use of a safety monitor on a low slope roof.