Osha Required Roof Parapet Holddown

1 every building constructed 3 stories or 36 feet or more in height shall have roof tie backs or other permanent devices installed at the roof level for the purpose of securing or tying back suspended scaffold hooks or clamps and safety lines.

Osha required roof parapet holddown.

The fall protection measures listed above are required for workers who operate felt laying machines or other equipment that is pulled backward no matter the potential fall height. When conditions warrant the height of the top edge may exceed the 45 inch height provided the guardrail system meets all other criteria of this paragraph. If a parapet wall is a minimum of 30 high and the height plus the width of the wall is a least 48 then it was determined that the fall hazard was removed and this was a compliant method to protect construction employees. For general industry employers must ensure that workers are protected at heights of 4 feet or more 1910 28 b 1 i.

Fall protection requirements for construction workers doing work while on a roof. This is in response to your fax submitted on september 2 2003 to the occupational safety and health administration osha and as a follow up to a telephone conversation on september 22 2003. Midrails when used must be installed midway between the top edge of the guardrail system and the walking working surface 29 cfr 1926 502 b 2 i. An exception to these measures is that the parapet must be at least 36 inches high and perpendicular to the direction of travel.