Osha Regulations For Fall Protection On Roofs

If there is a fall risk it needs to be addressed.

Osha regulations for fall protection on roofs.

When work is performed at least 6 feet 1 6 m but less than 15 feet 4 6 m from the roof edge the employer must ensure each employee is protected from falling by using a guardrail system safety net system travel restraint system or personal fall arrest system. Note to paragraph g. Section 1910 28 establishes the requirements that employers must follow on the use of cages and wells as a means of fall protection. Implement safe work practices to reduce the possibility of falls.

This section highlights osha standards federal register notices rules and proposed rules preambles to final rules background to final rules directives instruction to osha staff letters of interpretation official letters of interpretation of the standards and national consensus standards. Platforms used with fixed ladders provide a horizontal surface of at least 24 inches by 30 inches 61 cm by 76 cm. Osha safety standards especially for roof fall protection can be a source of confusion for many industrial companies. Answer as explained below the answer is no.

Understand the requirements of osha s fall protection standards at 29 cfr 1926 subpart m to protect workers exposed to falls six feet or more above a lower level. Background osha s fall protection standard for construction 29 cfr part 1926 subpart m beginning at 1926 500 generally requires fall protection when there is a fall distance of 6 feet or more. Also the warning line would comply with the criteria requirements in 1926 502 f. The answer is it doesn t matter how far from the edge.

Two osha standards can apply 29 cfr 1910 which governs general industry safety standards and 29 cfr 1926 which governs construction sites specifically. Supervise workers to ensure fall protection equipment is used and maintained correctly. Fall protection for activities not in the construction industry is addressed in specific standards for the general industry shipyard employment marine terminals and longshoring industry. How far from the edge do you have to be before fall protection is required.

In construction activities fall protection is required when working at heights greater than 6 feet with some exceptions. 1926 502 a 2 employers shall provide and install all fall protection systems required by this subpart for an employee and shall comply with all other pertinent requirements of this subpart before that employee begins the work that necessitates the fall protection. This is important because the osha definition is used as a basis for implementing low slope fall protection measures such as warning line systems and safety monitors. Except as otherwise provided in paragraph b of this section each employee engaged in roofing activities on low slope roofs with unprotected sides and edges 6 feet 1 8 m or more above lower levels shall be protected from falling by guardrail systems safety net systems personal fall arrest systems or a combination of warning line system and guardrail system warning line system and safety net system or warning line system and personal fall arrest system or warning line system and.