Osha Edge Of Roof Requirements

Is there a safe distance from the edge of a roof for construction workers doing work while on a roof but not engaged in roofing residential pre cast erection or leading edge work.

Osha edge of roof requirements.

6 feet from the edge. Your letter proposes to place the control lines 10 feet off the leading edge. Under that section an employer may use a combination of warning lines 6 feet and in some cases 10 feet back from the edge in combination with monitors in place of personal fall protection equipment or guardrails. Employers are to ensure that each employee is protected from falling by using fall.

Unprotected sides and edges. The regulation states that work at less than 6 feet from the roof edge requires. Between 6 feet and 15 feet from the roof edge. The new rule provides some clarification to this despite osha s previous stance that there is no safe distance.

The occupational safety and health administration has set new guidelines for inspecting commercial roofs. If you choose to walk on a roof without these you will be out of compliance with osha regulations and subject to fines. The best solution and the simplest is to install roof edge guard railing around the trouble spots to eliminate the fall hazard completely. Osha regulations for commercial roof inspections.

As stated in the standard control lines must be between 6 feet and 25 feet from the leading edge. Section 1926 501 b 10 sets out the fall protection requirement for roofing work on low slope roofs. Between 6 feet and 15 feet from the edge. Conventional fall protection guardrail fall restraint or fall arrest system is required.

Employers are to ensure. Industry standard says that protection must be in place for anyone working within 15 feet of the roof edge. Because 10 feet falls within the range stated in the standard control lines placed 10 feet off tie leading edge comply with 1926 502 g l i. Conventional fall protection guardrail fall restraint or.

These include using roof anchors and safety cords for roof inspections. Answer background in 29 cfr part 1926 subpart m fall protection 1926 501 b 1 states. Osha defines what fall protection is required based on how close employees are to the edge of the roof. For general industry working at a 4 foot height or a low sloped roof osha requires.

Osha requires that workers exposed to a fall hazard must have fall protection. Less than 6 feet from the roof edge.